Filter
Top Products
443Basic Procedure for Wipe Settings
Chapter 5 Wipes
6
In the <Main/Sub Link> group, make the main/sub modifier link function
settings. (See “Main and sub modifier link function” (page 63).)
Full: fully linked mode
Semi: semi-linked mode
Applying the effect of a diamond dust wipe to the selected
pattern (Dust mix)
1
In the Pattern Mix menu, press [Dust Mix], turning it on.
2
Set the following parameters as required.
You can also apply the dust mix function to the pattern generated by a
pattern mix.
Note
When a random/diamond dust wipe (pattern numbers 270-274) is selected,
the dust mix function is not available.
Setting Wipe Modifiers
You can apply various modifiers to the wipe pattern: setting the wipe direction,
pattern position, and so on.
For an overview of the wipe modifiers, see “Wipe Pattern Variation and
Modifiers” (page 63).
Note that the available modifiers may depend on the pattern you are using. For
details, see “Possible combinations of wipe patterns and modifiers” (page
454).
Main pattern and sub pattern modifiers
You can make independent settings of the modifiers for the main pattern and
sub pattern.
Knob Parameter Adjustment Setting values
1 Mix Ratio Proportion of diamond dust
pattern in mix
0.00 to 100.00
2 H Size Particle width 0.00 to 100.00
3 V Size Particle height 0.00 to 100.00
4 Flash Rate Rate of generation of particles 0.00 to 100.00