Filter
Top Products
473Basic Procedure for DME Wipe Settings
Chapter 6 DME Wipes
2
In the <Ch Select> group, select the target channels.
3
Press [Position] in the <Position> group, turning it on.
4
Set the following parameters.
For details of the method of DME wipe pattern selection, see “DME Wipe
Pattern Selection” (page 466).
Setting the DME wipe pattern size (Size)
1
In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
Press [Size], turning it on.
4
Set the following parameters.
a) The effect size when [Size] is off is taken as 100.00%.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Knob Parameter Adjustment Setting values
4 Relative H Relative movement in the
horizontal direction
–400.00 to +400.00
5 Relative V Relative movement in the vertical
direction
–400.00 to +400.00
Knob Parameter Adjustment Setting values
1 Size Set size of effect
0.00 to 200.00
a)