Filter
Top Products
Appendix B: Maintenance
MTM400 MPEG Transport Stream Monitor User Manual B-3
Figure B-2: Rack mounted sections
The chassis section is already installed on the unit. The position of the rear rack
mounting can be adjusted to suit the depth of the rack. Approximately six inches of
clearance is required between the rear panel of the unit and any rear cabinet panel
to allow for connector space and adequate air circulation.
Installing the MTM400 Unit
Refer to Figure B-3 to install the unit in the rack.
1. Pull the slide-out track section to the fully extended position.
2. Insert the MTM400 chassis sections into the slide-out sections.
3. Press the stop latches and push the unit toward the rack until the latches snap
into their holes.
4. Press the stop latches again and push the unit fully into the rack.
5. Tighten the front panel retaining screw.