Filter
Top Products
Receiving a Fax 63
Setting RX printing during default setup
The received data are printed on paper which fits the incoming original size.
y When the incoming original is shorter or the same length as the paper printing area, it is
printed in the original size.
y When the incoming original is larger than the paper printing area, it is printed according to
the following priority.
Default setting: Discard printing: ON
Reduction printing: ON
To change the configuration, see the following pages.
P.199 “Reduction printing”
P.200 “Discard printing”
1. Originals are printed on larger size paper.
2. When originals are up to 10 mm larger than the printing area, the part of the originals that
exceeds the paper printing area is discarded.
3. When originals are at least 10 mm larger than the printing area; If the original can fit on a sin-
gle sheet of paper by reducing it to 90%* of its original size, it is reduced and printed on a
sheet of paper (Reduction printing). If the original cannot fit on a single sheet of paper, it is
printed on 2 sheets of paper.
* e.g.) LD size originals are reduced to 71% to fit onto LT or LT-R paper.