Filter
Top Products
3 Tests and Diagnostics 3.24 SETUP
9. Configuration
This option lets you set the device configuration.
Setup by OS Operating system sets devices that it can control. (Default)
All Devices BIOS sets all devices.
NOTE: When using installed OS, selecting “Set by OS” is recommended. But, when
setting “PC CARD-Controller Mode” to other than “ Auto-Selected”, select “ All
Devices”.
10. DRIVES I/O
This option set the HDD, CD-ROM and PC card.
(a) Build-in HDD
Displays an address and interrupt level for the hard disk drive.
(b) PC Card
Displays an address and interrupt level for a PC card type of hard disk drive
that can boot the computer, when the computer is booted by the drive.
11. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for
information only and cannot be changed.
PCI BUS = IRQ11
12. PC Card
This option displays the PC Card Controller mode. When “Device Config.” is set to
“All Devices”, it can be changed.
Auto-Selected Use this setting when OS supports Plug&Play. (Default)
Card Bus/16 bit Use this setting when Cared Bus does not work properly in
“Auto-Selected” or PC card supports 16-bit.
PCIC Use this setting when using a 16-bit PC card which does
not operate correctly in Auto-Selected or CardBus/16-bit.
3-70 PORTEGE R100 Maintenance Manual (960-440)