Filter
Top Products
3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
Use the up and down arrow keys to move the cursor to “ERROR STOP”.
Use the right and left arrow keys to move the cursor to the desired option and press
Enter.
Selecting YES of ERROR STOP stops the test program when an error is found and
displays the operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
Press [1] Terminates the test program and returns to the subtest menu.
Press [2] Continues the test.
Press [3] Restarts the test from the error.
Selecting NO of ERROR STOP keeps the test running even if an error is found.
When an error occurred, the error status is displayed and the error counter is
increased by one.
6. Table 3-1 in section 3.3 describes the function of each test on the subtest menu. Table
3-2 in section 3.17 describes the error codes and error status for each error.
3-6 PORTEGE R100 Maintenance Manual (960-440)