Filter
Top Products
4 Replacement Procedures 4.12 LAN/MODEM jack
4.12 LAN/MODEM jack
Removing the LAN/MODEM jack
The following describes the procedure for removing the LAN/MODEM jack. (See Figure
4-23.)
1. Peel off the two glass tapes securing the MODEM cable.
2. Disconnect the LAN cable from PJ4100 on the system board.
3. Remove the LAN/MODEM jack from the slot.
Figure 4-23 Removing the LAN/MODEM jack
Installing the LAN/MODEM jack
The following describes the procedure for installing the LAN/MODEM jack. (See Figure
4-23.)
1. Install the LAN/MODEM jack to the slot.
2. Connect the LAN cable to PJ4100 on the system board.
3. Secure the MODEM cable with two glass tapes.
4-32 PORTEGE R100 Maintenance Manual (960-440)