Filter
Top Products
4.19 Fluorescent Lamp 4 Replacement Procedures
3. Removing the bezel
1) Place the module with the insulation sheet facing upwards.
2) Release three latches of the upper bezel and frame. Release four latches (two
each on both sides), peeling off the double-adhesive tape on the back of the
bezel slowly, then remove the bezel.
3) Release four latches of the bottom bezel and frame and slowly peel off the
double-adhesive tape on the back of the bezel. (The bezel with double-adhesive
tape will be reused.)
Caution: 1) When peeling off the latches and the double-faced tapes, be careful not to
damage the TAB.
2) When removing the bezel, do not break it and do not deform the bezel.
(The bezel with double-adhesive tape will be reused.)
4. Opening up the PCB
1) Open the PCB to the horizontal position as shown in the figure below.
Caution: Be careful not to damage the FPC.
Figure 4-42 Replacing Toshiba fluorescent lamp(4)
PORTEGE R100 Maintenance Manual (960-440) 4-53