Filter
Top Products
3.2 Executing the Diagnostic TestExecuting the Diagnostic Test 3 Tests and Diagnostics
3.2 Executing the Diagnostic Test
To start the DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the test program disk (No.1) in the floppy disk drive.
2. Turn on the computer by pressing the F12 key and, select the FDD in the display for
selecting booting unit. Then press ENTER. The following menu will appear:
TOSHIBA personal computer XXXX DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 20XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 – HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
NOTE: To exit the DIAGNOSTIC TEST MENU, press the [Esc] key. If a test program is
in progress, press[ Ctrl] + [Break] to exit the test program. If a test program is in
progress, press [Ctrl] + [C] to stop the test program.
PORTEGE R100 Maintenance Manual (960-440) 3-3