Filter
Top Products
_______________________________________ Configuration 6-27
Note: Throughout this document, all references to media are shown
as PAPER (the factory default). The same menu settings
apply to Film, Hvypaper (heavy paper), Hvyfilm (heavy
film), and five user-defined types of media.
The MEDIA:CONFIG menu allows you to select media types and
choose submenus to configure that media’s Density (Positive Film
Technology), EP1 (toner control), EP2 (humidity control), Fuser
Temperature, and NEIT (if available).
Positive Film Technology (Density)
Positive Film Technology allows you to control the toner intensity
for positive film output. The amount of toner applied to a positive
image increases as the PAPER:DENSITY configuration menu
settings increase from 0 to 20. The default setting depends on the
selected media. The default for paper and film it is 7.
This menu is active only if Negative Print is set to False in the Print
dialog box.
Electrophotography (EP1, Toner Control)
The PAPER:EP1 menu helps reduce toning by controlling the level
of toner transferred from the toner drum to the media. Options are 0
up to 15. The default setting depends on the selected media. The
default setting for paper and film is 10.
Electrophotography (EP2, Humidity Control)
The PAPER:EP2 menu allows you to make adjustments for changes
in humidity during printing, thereby reducing ghosting. Humidity
can affect toning on plates and the density on negatives.
Options are 0 to 10. The default depends on the selected media; the
defaults are 5 for paper and heavy paper, and 3 for film and heavy
film.
Note: This setting will affect the density of your halftones, so you
may need to relinearize if you change the EP2 setting.