Filter
Top Products
Phaser® 6128MFP Multifunction Printer
11
Printer Location
Place the printer in a dust-free area within a temperature range of 50° F to 90° F (10° C to
32° C) and a relative humidity range of 10 percent to 85 percent.
Humidity should be 70 percent or below at 90° F, and temperature should be 82° F or
below at 85 percent humidity.
Note: Sudden temperature fluctuations can affect print quality. Rapid heating of a cold
room can cause condensation inside the machine, directly interfering with image transfer.
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
• 32 cm (12.6 in.) above the printer
Total Height Requirements:
• Printer: 90.5 cm (35.6 in.)
Other Clearances:
• 10 cm (3.9 in.) behind the printer
• 60 cm (23.6 in.) in front of the printer
• 10 cm (3.9 in.) on the left side of the printer
• 25 cm (9.8 in.) on the right side of the printer
Operational Guidelines
• Do not block or cover the slots and openings on the printer. The printer may overheat
without adequate ventilation.
• For optimum performance, use the printer at elevations below 3,500 m (11,480 ft.).
• Do not place the printer near a heat source.
• Do not place the printer in direct sunlight to avoid exposing light-sensitive components
when the doors are open.
• Do not place the printer in line with the cold air flow from an air conditioning system.
• Place the printer on a level, solid, non-vibrating surface with adequate strength for the
weight of the printer. It should be within 1° of horizontal with all four feet in solid
contact with the surface. The printer weight with consumables is 29 kg (63.9 lb.).
• Do not place the printer in locations exposed to magnetic forces.
• Do not place the printer in damp locations.
• Do not place the printer in locations susceptible to vibrations.