Filter
Top Products
Administrator Tools
WorkCentre 7755/7765/7775 Multifunction Printer
System Administrator Guide
155
Setting the Date and Time
Setting the Date and Time in CentreWare IS
Note: If your printer is locked, you must log in as a system administrator. For details, see Accessing
CentreWare IS on page 17.
1. In CentreWare IS, click Properties > General Setup > Date and Time.
2. Under Date and Time Setup, select:
• Automatic using NTP to use an NTP server.
• Manual (NTP Disabled) to manually set the time.
3. If you are using an NTP server, provide the following information about the server:
• Select an address type. Options are IPv4 Address or Host Name.
• Type the appropriately formatted address, alternate address, and port numbers.The default
port number is 123.
Note: Changes to these settings will cause the printer to restart.
4. Select the date and time format, and type the date and time in the appropriate fields. Select
Display 24 hour clock to show the time in 24 hour format.
5. Under Time Zone, select your Time Zone from the drop-down menu.
6. Click Apply.
Setting the Date and Time at the Control Panel
Note: If your printer is locked, you must log in as a system administrator. For details, see System
Administrator Access at the Control Panel on page 15.
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Device Settings > General > Date and Time.
3. To set the time zone, touch GMT Offset and touch the arrows to adjust the time zone.
4. To set the date, touch Date, select a Format and type the date.
5. To set the time, touch Time, and type the time. Select Display 24 hour clock to use 24 hour
format.