Filter
Top Products
Scan using Template (Network Scanning) Setup
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide 131
If problems are encountered during machine setup, refer to the Problem Solving
chapter of the User Guide.
Scan using Template Environments
Network
The machine and the computer must be connected to a network and be able to
communicate using TCP/IP protocol.
Installation Procedure
To send the scanned document to a server using a template, configure the following
settings on the machine:
Network Communication Setup
By using the touch screen, activate the Internet Services (HTTP), FTP Client, or SMB
port to [Enabled].
Then, set the IP address.
Workstation Setup
This requires the workstation in the networking environment to be configured to
communicate with the machine.
Network Communication Setup
NOTE: CentreWare Internet Services can also be used to configure the machine.
Refer to the CentreWare Internet Services chapter of the User Guide.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
Initially, activate the port.
1. Connect the machine to the network.
2. Display the [System Settings] screen.
NOTE: For more information about how to display the [System Settings] screen, refer
to the Setups chapter of the User Guide.
3. Select [Network Settings].
4. Select [Port Settings].
Kerberos Server IP or Name if Remote Authentication is required, likewise
DNS Server Address or Domain Name if Kerberos Server Name is used.
Customer
Item By