Filter
Top Products
3NetWare
42 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide
NetWare Environments
System configuration
The machine supports NetWare PServer mode in Bindery or NDS. NetWare 3.x/4.x/
5.x/6.x is required to support Bindery. NetWare 4.11 or later is required to support NDS.
In the PServer mode, the machine will function as a print server and print jobs from the
print queue. The machine uses one file server user license.
NOTE: The machine does not support RPrinter mode.
Target computers
The NetWare versions and NetWare client computers require the following
environments.
NetWare versions
A Novell-accredited computer which can be installed with NetWare 3.x/4.x/5.x/6.x.
NetWare client computers
A Novell-accredited computer which can run Windows 95, Windows 98, Windows NT
4.0 or Windows 2000.
NOTE: When using the LPD port by Novell Distributed Print Services (NDPS), activate
the LPD port on the machine and set the IP address.
IPX/SPX frame types
The machine supports the following Ethernet interfaces.
• 10Base-T (Twisted Pair Cable)
• 100Base-TX (Twisted Pair Cable)
The machine supports the following frame types.
• Ethernet II specification
• IEEE802.3 specification
• IEEE802.3/802.2 specification
• IEEE802.3/802.2/SNAP specification
The machine will send out packets of each frame type on the connected network. It will
automatically use the frame type which corresponds to the first response. However, if
more than one protocol is running simultaneously on the same network, the machine
will use the same frame type as used by the NetWare server.
NOTE: Some network components, such as the hub may not support automatic frame
type setup. If the data link indicator light of the port does not light up, match the IPX/
SPX setting of the frame type of the machine, to the frame type of the file server.