Filter
Top Products
Initialize Card
This selection initializes the optional memory card.
CAUTION: Perform this operation only when it is necessary to erase all
previously stored information in the optional memory card. Otherwise, press
the NEXT key to bypass this function and display SENSOR PROFILE.
INITIALIZE CARD
YES
1. Press the right oval key to select “YES”. If your printer is set to require a password, you will now
be prompted to enter the password. Enter the password then press the NEXT key.
INITIALIZE CARD
YES
2. The display will ask “INITIALIZE CARD?” Press the right oval key to select “YES”. The front
panel LCD will ask “ARE YOU SURE?”
ARE YOU SURE?
NO YES
3. Press the right oval key to select “YES” and begin the initialization. or
Press the left oval key “NO” to cancel the request and return to the “INITIALIZE CARD” prompt.
4. Press the SETUP/EXIT key followed by the NEXT key.
If initialization is still in process, the front panel display will flash back and forth between the
two phrases “CHECKING B: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer will automatically exit the configuration mode and the
front panel will display “PRINTER READY”.
NOTE: Depending on the amount of memory in the memory card, initialization
may take up to five minutes to complete.
Configuration and Calibration
170PAX2-Series User’s Guide 17