Filter
Top Products
Selecting the Ribbon Low Feature
When the Ribbon Low feature is enabled, the “Ribbon Low” output signal (Pin 9) on the applicator
port is functional. When the amount of ribbon on the supply spindle reaches a specific low level, the
output signal will assert HIGH to provide a “Ribbon Low” warning.
When the Ribbon Low feature is disabled, the output signal (Pin 9) will not function, the “Low
Ribbon” warning is not displayed, and the printer will continue to print until it runs out of ribbon.
RIBBON LOW MODE
¬ ENABLED ®
Press the right or left oval key to display other selections.
Default: Enabled
Selections: Enabled, Disabled
Press the NEXT key to display REPRINT MODE.
Reprint Mode
When the Reprint feature is enabled, the “Reprint” input signal (Pin 6) on the applicator port is
functional. When the input signal is asserted, the last label printed will be printed again. (This
includes non-printing labels.) When the Reprint feature is disabled, the “Reprint” input signal is
ignored.
NOTE: The ^SP command is ignored when the Reprint feature is enabled.
When the Reprint feature is disabled, the ^SP command can be used. In addition,
when a received label format is canceled prior to printing, the “reprint” function
for the previous label is also canceled.
REPRINT MODE
¬ DISABLED ®
Press the right or left oval key to display other selections.
Default: Disabled
Selections: Disabled, Enabled
Press the NEXT key to display WEB SENSOR
Sensor Values
The following eight parameters — Web Sensor, Media Sensor, Ribbon Sensor, Mark Sensor,
Mark Media Sensor, Media LED, Ribbon LED, and Mark LED — are automatically calculated
during the calibration procedure and typically do not require adjustment. Additional information
about these values can be found in the 170PAX-Series Maintenance Manual (P/N 49803L).
Press the NEXT key to display LCD ADJUST.
Configuration and Calibration
170PAX2-Series User’s Guide 31