Filter
Top Products
To replace a fuse, follow this procedure and refer to Figure 22:
1. Turn off the printer and unplug the power cord from the back of the printer.
2. Using a small-blade screwdriver, remove the fuse holder from the power entry module at the rear
of the printer.
3. Carefully remove the fuse from the “in circuit” location. To remove the fuse from the “spare”
location, insert the point of a pencil through one of the two holes in the fuse holder; gently push.
Repeat this procedure through the other hole.
4. Insert this fuse in the “in circuit” location. (Remember to replace an approved 250 VAC, 5 Amp
fuse in the “spare” location!)
5. Reinstall the fuse holder into the power entry module at the rear of the printer.
6. Reconnect the power cord and turn the printer on.
The printer should now be ready for operation and the POWER light should be on.
NOTE: If power is not restored, an internal component failure may have
occurred and the printer requires servicing. Refer to “Troubleshooting.”
Shipping
To ship the Zebra 170PA X 2-Series print engine, remove all ribbon and media. Carefully pack the print
engine in a suitable container to avoid damage during transit. Whenever possible, use the original
“carton within a carton” packing materials from the factory. A shipping container can be purchased
from Zebra Technologies Corporation if the original packaging is lost or destroyed. Contact your
distributor or Zebra Technologies Corporation to order the 170PA X 2-Series Packing Materials Kit.
If you use a different container, package the print engine carefully to avoid damage.
CAUTION: When packaging the printer in a rigid container, use shock
mounts or shock-absorbing packing material.
54 170PAX2-Series User’s Guide
Appendix A
Figure 22. Installing a Fuse