Agilent Technologies Switch/Measure Switch User Manual


 
6 34980A User’s Guide
1 Introduction to the 34980A
Front Panel Menu Reference
This section gives an overview of the top two levels of menus that you access
from the front panel. The menus are designed to automatically guide you
through all parameters required to configure a particular function or
operation.
Store/Recall Store and recall instrument states
Store up to six instrument states in non-volatile memory
Assign a name to each storage location.
Recall stored states, power-down state, factory reset state, or preset state
Utility Configure system-related instrument parameters
Connecting and configuring to use with LAN, GPIB, or USB
Set the real time clock and calendar
Set radix character, thousand separator
Enable/disable the internal DMM
Secure/unsecure the instrument for calibration
Query and update the firmware revisions for the mainframe and modules
Configure Key Group Set parameters for measurement
DMM
Set DMM measurement function (AC volts, DC volts, AC current, DC current, 2-wire ohms, 4-wire ohms,
temperature, frequency, and period
Set function parameters
Channel
Set channel measurement function (AC volts, DC volts, AC current (34921A only), DC current (34921A only)
2-wire ohms, 4-wire ohms, temperature, frequency, and period
Set function parameters
Scan
Set up trigger-in parameters
Set up sweep count
Set up sample count
Sequences
Available at a later firmware release
Module
Open all relays
Clear all measurement functions
Clear channel labels
Configure external trigger and clock (34951A)
Set trace or level mode (34951A)
Set waveform parameters (34951A)