Filter
Top Products
200 34980A User’s Guide
10 Multifunction Module with DIO, D/A, and Totalizer
The following command configures totalizer channel 5 on the
Multifunction module in slot 2 to be reset to "0" after it is read (RRESet
means “read and reset”).
CONFigure:TOTalize RRES,(@2005)
Example: Configuring the totalizer for count This command configures the
totalizer to count on the rising edge (positive) or falling edge (negative) of the
input signal. The following command configures the totalizer (channel 5) on a
Multifunction module in slot 3 to count on the negative edge (falling) of the
input signal.
TOTalize:SLOPe NEGative,(@3005)
Example: Clearing count on the totalizer channel This command immediately
clears the count on the specified totalizer channels. The following
commandclears the count on the totalizer (channel 5) on a Multifunction
module in slot 3.
TOTalize:CLEAR:IMMediate (@3005)
DAC Output
Example: Setting output voltage This command sets the output voltage level
for the specified DAC channels. The following command outputs +2.5 V DC on
DAC channels (6 and 7) of a Multifunction module in slot 4.
SOURce:VOLTage 2.5,(@4006,4007)
Configuring a Multifunction Module
Example: Querying the system for module identify The following command
returns the identify of the module installed in slot 7.
SYSTem:CTYPe? 7
Example: Resetting module(s) to power-on state The following command
resets a module in slot 4 to its power- on state.
SYSTem:CPON 4