Filter
Top Products
Chapter 4 BIOS Setup Utility
74 Reference Manual XTX 820
♦ S.M.A.R.T. – [Auto], [Disabled], or [Enabled]
♦ 32Bit Data Transfer – [Disabled] or [Enabled]
> Third IDE Slave: – [Not Detected] or [Device Type]
The descriptions used for the Primary IDE Master are the same for the Third IDE Slave except
where noted.
∗ If the BIOS does not detect a device on the Third IDE Slave channel, [Not Detected] will be
displayed. You can still go to the submenu to set options for an IDE device.
∗ If the BIOS auto detects a IDE device, the device will be displayed [Hard Disk for example]
with the parameters automatically selected.
♦ Type – [Not Installed], [Auto], [CD/DVD], or [ARMD]
∗ If [Not Installed] appears due to Not Detected, the balance of the options for Third IDE
Slave may not appear on screen.
♦ LBA/Large Mode – [Disabled] or [Auto]
♦ Block (Multi-Sector Transfer) – [Disabled] or [Auto]
♦ PIO Mode – [Auto], [0], [1], [2], [3], or [4]
♦ DMA Mode – [Auto], [SWDMA0], [SWDMA01], [SWDMA2], [MWDMA0], [MWDMA1],
[MWDMA2], [UDMA0], [UDMA1], [UDMA2], [UDMA3], [UDMA4], [UDMA5], or
[UDMA6]
♦ S.M.A.R.T. – [Auto], [Disabled], or [Enabled]
♦ 32Bit Data Transfer – [Disabled] or [Enabled]
• Hard Disk Write Protect – [Disabled] or [Enabled]
>Fourth IDE Master: – [Not Detected] or [Device Type]
The descriptions used for the Primary IDE Master are the same for the Fourth IDE Master except
where noted.
∗ If the BIOS does not detect a device on the Fourth IDE Master channel, [Not Detected] will be
displayed. You can still go to the submenu to set options for an IDE device.
∗ If the BIOS auto detects a IDE device, the device will be displayed [Hard Disk for example]
with the parameters automatically selected.
♦ Type – [Not Installed], [Auto], [CD/DVD], or [ARMD]
∗ If [Not Installed] appears due to Not Detected, the balance of the options for Fourth IDE
Master may not appear on screen.
♦ LBA/Large Mode – [Disabled] or [Auto]
♦ Block (Multi-Sector Transfer) – [Disabled] or [Auto]
♦ PIO Mode – [Auto], [0], [1], [2], [3], or [4]
♦ DMA Mode – [Auto], [SWDMA0], [SWDMA01], [SWDMA2], [MWDMA0], [MWDMA1],
[MWDMA2], [UDMA0], [UDMA1], [UDMA2], [UDMA3], [UDMA4], [UDMA5], or
[UDMA6]
♦ S.M.A.R.T. – [Auto], [Disabled], or [Enabled]
♦ 32Bit Data Transfer – [Disabled] or [Enabled]