Filter
Top Products
Layer 3 CLI Commands
Avaya X330W-2DS1 User’s Guide 89
router ospf
Use the router ospf command to enable OSPF protocol on the system and to
enter the Router Configuration context. . The no form of this command disables it
globally. The default is disabled.
The syntax for this command is:
[no] router ospf
router rip
Use the router rip command to enable the Routing Information Protocol (RIP)
and to emter tje Router Configuration context. The no form of this command
disables RIP. The default state is disabled.
The syntax for this command is:
[no] router rip
Example:
To enable the RIP protocol:
X330WAN-2DS1-1(configure)# router rip
X330WAN-2DS1-1(configure)# router: rip #
router vrrp
Use the router vrrp command to enable VRRP routing globally. Use the no
form of this command to disable VRRP routing.
Note: You cannot activate both VRRP and SRRP protocols at the same time.
The syntax for this command is:
[no] router vrrp
show ip arp
Use the show ip arp command to display the Address Resolution Protocol
(ARP) cache.
The syntax for this command is:
show ip arp
[<interface>| <IP interface> | <ip addr> [<ip mask>] | static]
interface String up to 32 characters