Filter
Top Products
WAN CLI Commands
Avaya X330W-2DS1 User’s Guide 121
The syntax for this command is:
[no] bandwidth [<kilobits size>]
Example:
X330WAN-2DS1-1(super-if:FabricFastEthernet1:1)# bandwidth 100
cablelength long (Controller Context)
Use the cablelength long command to configure transmit and receive levels
for a cable length (line build-out) longer than 655 feet for a T1 trunk with a CSU
interface. Use the no form of this command to restore the cablelength long
parameters to their default (Tx=0db level, Rx=gain26).
Note: This command can only be performed if the controller is set to T1.
The syntax for this command is:
[no] cablelength long {gain26|gain36} {-15db|-22.5db|-7.5db|
0db}
kilobits size An integer (1-10000000)
long Configures parameters using gain/attenuation.
gain26 Sets the receive sensitivity to 26 dB if you can
configure the hardware’s receive sensitivity. This is
the default value. However, it is recommended to
enter gain26 so that the CLI entry matches the
actual value.
gain36 Sets the receive sensitivity to 36 dB if you can
configure the hardware’s receive sensitivity.
-15db Sets the transmit attenuation to 15 dB.
-22.5db Sets the transmit attenuation to 22.5 dB.
-7.5db Sets the transmit attenuation to 7.5 dB.
0db Sets the transmit attenuation to 0 dB. This is the
default value.