Filter
Top Products
Chapter 7 X330WAN CLI Commands
126 Avaya X330W-2DS1 User’s Guide
controller’s description.
Note: This command can also be executed from the Serial, Loopback, Fast Ethernet
and Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] description <desc>
Examples:
X330WAN-2DS1-1(config-controller:1)# description "E1
controller"
X330WAN-2DS1-1(config-controller:1)# no description
description (Interface context)
Use the description command to set the description of the interface. Use the no
form of this command to remove the interface’s description.
Note: This command can also be executed from the Serial, Loopback, Fast Ethernet
and Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] description <desc>
Examples:
X330WAN-2DS1-1(config-if:FastEthernet1)# description vlan5
ds-mode
Use the ds-mode command to set the controller’s mode.
desc A string describing the E1/T1 interface. The string may contain
blanks and is up to 255 characters long.
desc A string describing the interface.