Filter
Top Products
Chapter 7 X330WAN CLI Commands
74 Avaya X330W-2DS1 User’s Guide
ip ospf cost (Interface context)
Use the ip ospf cost command to configure interface metric. The no form of
this command sets the cost to its default. The default is 1.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip ospf cost <cost>
Example:
ip ospf cost 10
ip ospf dead-interval (Interface context)
Use the ip ospf dead-interval command to configure the interval before
declaring the neighbor as dead. The no form of this command sets the dead-
interval to its default. The default is 40.
Note: This command is executed from the Serial, Loopback, Fast Ethernet and
Fabric Fast Ethernet interfaces.
The syntax for this command is:
[no] ip ospf dead-interval <seconds>
Example:
ip ospf dead-interval 15
ip ospf hello-interval (Interface Mode)
Use the ip ospf hello-interval command to specify the time interval
between hello's the router sends. The no form of this command sets the hello-
interval to its default. The default is 10.
cost An integer in the range 1 to 65535.
seconds An integer in the range 1 to 65535.