Filter
Top Products
Chapter 7 X330WAN CLI Commands
72 Avaya X330W-2DS1 User’s Guide
ip max-route-entries
This command exists for compatibility with P550. There is no limitation on the size
of the routing table, except for the amount of available memory. Use the no form of
this command to set the maximum number of route entries in the routing table to its
default value.
The syntax for this command is:
[no] ip max-route-entries <value>
ip netbios-rebroadcast (Interface context)
Use the ip netbios-rebroadcast command to set NETBIOS rebroadcasts
mode on an interface. The no form of this command disables NETBIOS
rebroadcasts on an interface.
Note: This command is executed from the Serial, Fast Ethernet and Fabric Fast
Ethernet interfaces.
The syntax for this command is:
[no] ip netbios-rebroadcast [<direction>]
The possible values of direction is:
Example:
To enable rebroadcasting of netbios packets received by and sent from the interface
“marketing”:
X330WAN-2DS1-1(configure)# ip netbios-rebroadcast both
X330WAN-2DS1-1(configure)# ip netbios-rebroadcast
value number of entries. The range of accepted values is 100 to
20000.
both Netbios packets received on the interface
rebrodcasted to other interfaces and netbios packets
received on other interfaces are rebroadcasted into
this interface.
If no parameter is provided in the command, the
"both" optionis applied as the default.
disable Netbios packets are not rebroadcasted into or out of
this interface.