General: Device Commands
Avaya X330W-2DS1 User’s Guide 53
Output Example:
X330WAN-2DS1-1(super)# reset
This command will reset the module and may disconnect your
telnet session.
*** Reset the device *** - do you want to continue (Y/N)? y
Connection closed by foreign host.
set boot bank
Use the set boot bank command to configure the software bank from which the
device will boot at the next boot process.
The syntax for this command is:
set boot bank <value>
Output Example:
X330WAN-2DS1-1(super)# set boot bank bank-a
Boot bank set to bank-a
set logout
The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is:
set logout [timeout]
Output Example:
To set the number of minutes until the system disconnects an idle session
automatically:
X330WAN-2DS1-1(super)# set logout 20
Sessions will be automatically logged out after 20 minutes of
idle time.
value {bank-a | bank-b}
timeout Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions (default is 15 minutes).