Filter
Top Products
General: Device Commands
Avaya X330W-2DS1 User’s Guide 57
Output Example:
X330WAN-2DS1-1(super)# set time protocol sntp-protocol
The protocol has been set to SNTP protocol
Output Example:
X330WAN-2DS1-1(super)# set time protocol time-protocol
The protocol has been set to TIME protocol
set time server
The set time server command is used to set the TIME server address.
The syntax for this command is:
set time server <ip address>
set timezone
Use the set timezone command to assign a timezone name and set the time
difference of your WAN relative to the Coordinated Universal Time (UTC/GMT).
The minutes parameter can only be set to 30.
The syntax for this command is:
set timezone <zone name> <hours|hours:min>
Output Example:
set timezone GMT -3:30
Timezone set to 'GMT', offset from UTC is -3:30 hours
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
show boot bank
Use the show boot bank command to display the software bank from which the
ip address IP address of the TIME server.
zone name Three letter representation of the time zone.