Filter
Top Products
WAN CLI Commands
Avaya X330W-2DS1 User’s Guide 145
The syntax for this command is:
show interfaces [<type>] [<identifier>]
Examples:
X330WAN-2DS1-1(super)# show interfaces
FabricFastEthernet 1:1 is up, line protocol is up
Physical address is 00.40.0d.bf.3b.01,
MTU 1500 bytes, Bandwidth 100000 Kbit,
Encapsulation ARPA,
0 packets input, Received 0 broadcasts,
33175 input errors,
0 packets output,
0 output errors
FastEthernet 1 is up, line protocol is up
Physical address is 00.40.0d.bf.3b.fe,
Internet address is 149.49.75.71 , mask is 255.255.255.0
MTU 1500 bytes, Bandwidth 100000 Kbit,
Encapsulation ARPA,
Full-duplex, 100Mb, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
680031 packets input, Received 661406 broadcasts,
17 input errors,
5569 packets output,
0 output errors
FabricFastEthernet 1 is up, line protocol is up
MTU 0 bytes, Bandwidth 100000 Kbit,
Encapsulation ARPA,
0 packets input, Received 0 broadcasts,
0 input errors,
type The type of this interface. Select one of the following:
FastEthernet | Serial | FabricFastEthernet | Loopback | Console
identifier • For a FastEthernet interface - An integer (1)
• For a Serial interface - <port>:<channel-group>
<port> - Either 1 or 2
<channel-group> - For E1, an integer, 0-30
For T1, an integer, 0-23
• For a FabricFastEthernet interface - 1[:<vlan>]
<vlan> - An integer, 1-3071
• For a Loopback interface - An integer, 0-99