Filter
Top Products
8. Geometry Menu
8.5.9.4 Basic Softedge Shape Setup
The following procedures will adjust the Shape of a basic Electronic Soft Edge set up with 2 projectors and
a 12.5 % overlap zone, apply the same procedures for every Electronic Soft Edge you want to create in a
multi-projector system.
Image 8-129
Basic Electronic Soft Edge set up
Be sure Blanking / Softedge is set to On for both projectors (see "Blanking – Softedge", page 62).
Setting up the Shape for Projector 1
1. Use the combination of ENTER and the cursor key ← or → to select right all. (image 8-130)
2. Push the cursor key ↑ or ↓ to select % of image.
%ofimage Coarse adjustment, this will shift the blending zone in steps of 1
/100 of the total image shape.
%% of image Fine adjustment, this will shift the blending zone in steps of 1/10000 of the total image shape.
3. Push thecursor key← or→ to coincide theright sideof theimage ofProjector 1with the centerof theoverlap area. (image8-131)
4. Use the %% of image selection for fine adjustments.
Image 8-130
R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007 145