Filter
Top Products
5. Getting Started
Image 5-7
Lamp Runtime Warning
The total lamp runtime for a safe operation is max. 1500 hours, do not use it longer.
The Lamp Runtime
Warning is default set to 30 hours before the end of the lamp lifetime, to change this setting (see "Lamp Runtime
Warning", page 174).
The Lamp runtime warning will be displayed when this setting is reached, e.g. 30 hours before the end of the lamp runtime, and
from this moment on, at every start-up of the projector.
Press the BACK key on the RCU to remove this warning.
WARNING: Op
erating the lamp longer than 1500 hours may damage the projector.
WARNING: Alwaysreplace with thesame type of lamp, calla BARCO authorized service technicianto replace
the lamp
and reset the lamp runtime.
5.6 Switc
hing to Standby
How t
o Switch the Projector to Standby?
1. Press the STANDBY key for 2 seconds to switch the projector to Standby.
The cool down sequence is started, Led 1 will flicker for 60 seconds after switching to standby.
5.7 Swit
ching Off
Ho
w to Switch Off the Projector?
1. First switch the projector to Standby by pressing the STANDBY key for 2 seconds.
The cool down sequence is started, Led 1 will flicker for 60 seconds after switching to standby.
2. When the cool down sequence is finished switch ’Off’ the projector with the power switch.
R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007
37