Filter
Top Products
13. Installation Menu
What is Projector Address?
Each projector can be set to an individual Projector Address, this can be set between ’0’ and ’255’.
Projector Address
Controlled by
0–9
RCU
0–255
Computer (IBM PC or compatible, Apple, ...)
Regardless of the Projector Address, the projector will still respond to a RCU set to address ’0’ or ’1’ through
the Common Address.
What is Common Address 0?
Every projector has a Common Address default set to ’0’, when the RCU is set to address ’0’, every projector, without exception will
listen to the commands given by this RCU.
When to use Common Address 0?
• Since the RCU is default set to address ’0’, this is used by default to control the projector in a single projector setup.
• The Common Address is used to control multiple projectors using only a single RCU.
When to use Common Address 1?
Most RCU’s used by other electronic equipment are set to address ’0’, to disable the interference of other RCU’s the Common
Address of the projector(s) can be set to ’1’. When the projector’s RCU is set to address ’1’, every projector, without exception will
listen to the commands given by this RCU.
How to set the Projector and Common Address?
1. Press the MENU key to activate the Menu bar.
2. Push the cursor key ← or → to highlight Installation in the menubar.
3. Push the ↓ key to pull down the I
nstallation menu.
4. Push the cursor key ↑ or ↓ to highlight Project or Address and press ENTER to select. (image 13-7)
The Projector Address screen will be displayed. (image 13-8)
5. Use the cursor key ← or → , the numeric keys on the RCU, or the local keypad, to edit and change the values, confirm with
ENTER. (image 13-9)
Image 13-7
198 R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007