Filter
Top Products
10. Lamps Menu
Image 10-3
Single mode operation: switching principle
Dual Mode
Both lamps are working.
When one lamp fails, the projector continues the projection using the remaining lamp.
How to select the Lamp Mode?
1. Press the MENU key to activate the Menu bar.
2. Push the cursor key ← or → to highlight Lamps in the menubar.
3. Push the ↓ key to pull down the Lamps menu.
4. Push the cursor key ↑ or ↓ to highlight Mode.
5. Push the → key to pull down the Mode menu.
A bullet shows the active mode e.g. Single. (image 10-4)
6. Push the cursor key ↑ or ↓ to select the desired Lamp Mode and press ENTER to select.
The following message will be displayed. (image 10-5)
7. Press the ’Yes’ button to confirm, the ’No’ butt
on to cancel.
Note: W hen switching from dual mode to single mode the lamp with the longest runtime is switched off.
If the runtimes are equal, and if the projector has always been operated in dual mod e, then lamp 1 is switched off.
Note: W hen switching to single mode, returning to the dua l mode will not be possible in th e first 60 seconds, in the menu Dual
is grayed out and LED1 is flickering, thereb
y preventing a hot restrike which may damage the lamp.
8. Press BACK to return to the Lamp menu.
R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007
171