Filter
Top Products
E. Troubleshoot
E. TROUBLESHOOT
E.1 Troubleshoot
Troubleshoot
Before calling the Barco Service Center try the correct the operating problem by consulting the following troubleshoot list:
Operating
Problem
Solutions
No Power
• Check if the mains power is OK
• Check if the power cord is connected to the wall outlet (see "Power Cord Connection", page 26).
• Check if the Power Switch is set to ON (see "Switching On", page 36).
• Check if Led 3 lights red (see "Diagnose Leds", page 35).
No Image
• Check the connection between the source equipment and the projector (see "Connections", page 25).
• Check if the source equipment is connected to the wall outlet and the power is turned on.
• Select the correct input source again in the menu (see "Source Selection", page 41).
Displayed
Image is
reversed
• Check the orientation settings of the projector (see "Orientation", page 199).
Displayed
image is Dark
• Adjust the Brightness and Contrast (see "Contrast", page 62).
Only part of
the image is
displayed
• Load the correct source file (see "Load", page 184).
• Edit the source file settings to the correct values (see "Edit", page 185).
• (When applicable) Switch OFF Blanking - Softedge (see "Blanking – Softedge", page 62).
RCU is not
working
• Make sure the RCU is set to the correct Projector Address, check the Common and Projector Address
(see "Common Address", page 38).
• Check the RCU batteries, replace batteries when necessary (see "Battery In
stallation", page 23).
• Make sure you are within the RCU’s operating range 30m (100ft), and you are pointing the RCU
correctly (see "Pointing the RCU", page 38).
WARNING: Do no try to service this product yourself, as opening or removing covers may expose you to
dangerous voltage potentials and risk of electric shock!
Refer all servicing to qualified Barco service personnel!
R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007 237