Filter
Top Products
7. Image Menu
7.5.6 Blanking – Softedge
What can be done with Blanking – Softedge?
When setting up a soft edge (see Electronic Softedge), these settings are by default applied on all sources (source files). With the
Blanking – Softedge toggle it is possible to disable the Blanking – Softedge settings for the current source file.
Blanking – Soft Edge is default set to On.
How to change the Blanking – Softedge Setting?
1. Push the cursor key ↑ or ↓ to highlight Blanking – Softedge and press ENTER to select.
The Blanking – Softedge Setting will be displayed. (image 7-39)
2. Use the cursor key ↑ or ↓ to select On or Off.
3. Press ENTER to confirm.
Image 7-39
7.6 Settings
Overview
• Introduction
• Contrast
• Brightness
• Gamma
• Phase
• Sharpness
7.6.1 Introduction
Introduction
Within the Settings menu it is possible to adjust the general image settings.
7.6.2 Contrast
It is advised not to use the Contrast Adjustment in a multi channel application.
How to use the Contrast Adjustment?
1. Push the cursor key ↑ or ↓ to highlight Contrast... and press ENTER to select. (image 7-40)
Note: T h e Contrast value is by default set to 100.
The Contrast Sliderbox will be displayed. (image 7-41)
62
R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007