Filter
Top Products
3-51
FAX-L1000 Chapter 3: Technical Reference
b) Electrostatic latent image formation block
This block follows two steps to produce an electrostatic latent image on the photosensitive
drum.
When “Laser beam exposure” of this block is completed, negative charge remains in the
unexposed “dark” areas; however, those in the exposed “light” areas are eliminated.
This image of negative charges on the drum is invisible to the human eye, so it is called an
“electrostatic latent image.”
Figure 3-19 Surface Potential
b-1) Primary charging
Figure 3-20 Primary Charging
In preparation for the latent image formation, a uniform negative potential is applied to the
photosensitive drum surface. For primary charging, the printer uses the charging method,
which directly charges the drum.
The primary charging roller is made of conductive rubber. In addition to DC bias, AC bias
is also applied to the primary charging roller to keep the potential on the drum surface
uniform. The DC bias changes with the developing DC bias.
0
-100
-500
Time t
Exposed area
Unexposed
area
Laser beam exposure
Transfer
Primary
charging
Primary
charging
Surface potential (V)
Photosensitive drum
Primary charging roller
AC bias
DC bias