Filter
Top Products
4-63
FAX-L1000 Chapter 4: Maintenance and Service
##0773 [TX] Exceed protocol retransmission limit or T5 time (60 seconds)
after EOR-NULL transmission during ECM transmission
Cause: The other fax’s page buffer is full or is being used, so EOR-NULL was
transmitted, then RNR was received and after RR transmission, no
significant signals could be received.
Solution: (1) In the user data “TX SETTINGS”, set “ECM TX” to “OFF”.
(2) Set user data “TX START SPEED” in “SYSTEM SETTINGS” to
lower speed.
##0778 [TX] Exceed protocol retransmission limit or T5 time (60 seconds)
after EOR-MPS transmission during ECM transmission
Cause: The other fax’s page buffer is full or is being used, so EOR-MPS was
transmitted, then RNR was received and after RR transmission, no
significant signals could be received.
Solution: (1) In the user data “TX SETTINGS”, set “ECM TX” to “OFF”.
(2) Set user data “TX START SPEED” in “SYSTEM SETTINGS” to
lower speed.
##0783 [TX] Exceed protocol retransmission limit or T5 time (60 seconds)
after EOR-EOM transmission during ECM transmission
Cause: The other fax’s page buffer is full or is being used, so EOR-EOM was
transmitted, then RNR was received and after RR transmission, no
significant signals could be received.
Solution: (1) In the user data “TX SETTINGS”, set “ECM TX” to “OFF”.
(2) Set user data “TX START SPEED” in “SYSTEM SETTINGS” to
lower speed.
##0788 [TX] Exceed protocol retransmission limit or T5 time (60 seconds)
after EOR-EOP transmission during ECM transmission
Cause: The other fax’s page buffer is full or is being used, so EOR-EOP was
transmitted, then RNR was received and after RR transmission, no
significant signals could be received.
Solution: (1) In the user data “TX SETTINGS”, set “ECM TX” to “OFF”.
(2) Set user data “TX START SPEED” in “SYSTEM SETTINGS” to
lower speed.