Filter
Top Products
4-40
FAX-L1000 Chapter 4: Maintenance and Service
"CHECK POLLING ID" (#0008, #0021)
Cause: Polling was impossible because the polling ID or your subaddress/password
did not match.
Solution: Check the polling ID or subaddress/password with the other party and try
polling again.
"CHECK PRINTER"
See Printer error codes (##322
~
##325)
"CHECK PRINTER COVER"
Cause: (1) Displayed when the printer cover sensor detects an open cover.
(2) Displayed when the toner cartridge is not installed.
Solution: (1) Close the printer cover.
(2) Install a toner cartridge.
"CHECK SUBADDR/PASSWD" (#0083, #0102)
Cause: Password/subaddress does not match.
Solution: Contact the other party and confirm that the subaddress/password that you are
using are correct.
"COMMUNICATING PLEASE WAIT"
Cause: You tried to use direct sending while the fax was sending another document.
Solution: Wait until the transmission is finished, then try again.
"DATA ERROR PRESS SET KEY"
Cause: Check sum error. This is displayed when the SCNT board is replaced,
when the SRAM is defective, or when the backup battery is replaced.
Solution: Press the SET button.
"DOCUMENT TOO LONG" (#0003)
Cause: Displayed when one page of the document was longer than 39.4 inches (1
meter) or transmission/copying took longer than the regulated time (32
minutes).
Solution: (1) Use a copy machine to copy the document onto several
shorter pages, then transmit again.
(2) Reduce them on a copy machine if necessary. Then paste
them on standard letter or A4-size sheets for scanning.