Filter
Top Products
4-39
FAX-L1000 Chapter 4: Maintenance and Service
5.2 Error Shown on the Display
5.2.1 User error message
"# ALREADY IN USE"
Cause: The box specified with confidential or polling communications is already
in use.
Solution: Change the setting or select another box.
"AUTO REDIAL"
Cause: The other party’s line was busy on the previous dialing attempt and the fax
unit is dialing the number again.
Solution: To cancel redialing, press Stop button when direct dialing or press
Delete File, select transaction number then press Set when memory
sending.
"BUSY/NO SIGNAL" (#0005, #0018)
Cause: There was no response from the other fax within 35 seconds. (T1 timer
over)
Solution: (1) Transmit again. Since there is a possibility that the other
fax is not a G3 fax, check the other fax’s communications
mode.
(2) When send documents long distance, press Pause button
after dialing.
(3) There is a possibility that the other party has turned off the
fax unit.
"CHECK DOCUMENT"(#0001, #0011)
Cause: Document jam. This is displayed when the document sensor detects paper,
but the document edge sensor cannot detect the leading edge of the
document within 15 seconds from the start of the feed operation.
Solution: (1) Remove the document and try again.
(2) If the document does not feed correctly, clean the rollers.
Refer to
this chapter, 3. CLEANING
.
"CHECK PAPER SIZE" (when Printer board I is installed)
Cause: Paper-size-matching error of the MP tray. Set different paper size in the
fax menus and in the printer menus, or the USE MP TRAY menu is not
turned off while using the MP tray for the printer function and loading
paper of sizes other than letter, legal or A4.
Solution: Set the correct paper size in both of the fax and printer menus, or turn off
USE MP TRAY in the fax menus.