Filter
Top Products
44-9
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 44 Configuring Control Plane Policing and Layer 2 Control Packet QoS
Monitoring CoPP
Monitoring CoPP
You can enter the show policy-map control-plane command to develop site-specific policies, to monitor
statistics for the control plane policy, and to troubleshoot CoPP. This command displays dynamic
information about the actual policy applied, including rate information and the number of bytes (and
packets) that conformed or exceeded the configured policies both in hardware and in software.
The output of the show policy-map control-plane command is similar to the following:
Switch# show policy-map control-plane
Control Plane
Service-policy input: system-cpp-policy
Class-map: system-cpp-dot1x (match-all)
0 packets
Match: access-group name system-cpp-dot1x
Class-map: system-cpp-bpdu-range (match-all)
0 packets
Match: access-group name system-cpp-bpdu-range
* Class-map: system-cpp-cdp (match-all)
160 packets
Match: access-group name system-cpp-cdp
** police: Per-interface
Conform: 22960 bytes Exceed: 0 bytes
*
Class-map: system-cpp-sstp (match-all)
0 packets
Match: access-group name system-cpp-sstp
Class-map: system-cpp-cgmp (match-all)
0 packets
Match: access-group name system-cpp-cgmp
Class-map: system-cpp-hsrpv2 (match-all)
0 packets
Match: access-group name system-cpp-hsrpv2
Class-map: system-cpp-ospf (match-all)
0 packets
Match: access-group name system-cpp-ospf
Class-map: system-cpp-igmp (match-all)
0 packets
Match: access-group name system-cpp-igmp
Class-map: system-cpp-pim (match-all)
0 packets
Match: access-group name system-cpp-pim
Class-map: system-cpp-all-systems-on-subnet (match-all)
0 packets
Match: access-group name system-cpp-all-systems-on-subnet
Class-map: system-cpp-all-routers-on-subnet (match-all)
0 packets
Match: access-group name system-cpp-all-routers-on-subnet
Class-map: system-cpp-ripv2 (match-all)
0 packets