Filter
Top Products
50-7
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 50 Configuring Storm Control
Disabling Multicast Storm Control
The following example shows how to disable storm control on interface.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# int fa3/1
Switch(config-if)# no storm-control broadcast level
Switch(config-if)# end
Switch# show storm-control //Supervisor Engine 2+ to V-10GE
Interface Filter State Upper Lower Current
--------- ------------- ------- ------- -------
Switch#
Switch# show storm-control //Supervisor Engine 6-E
Interface Filter State Broadcast Multicast Level
--------- ------------- --------- --------- -----
Switch#
Disabling Multicast Storm Control
To disable multicast suppression on WS-X4516, WS-X4515, WS-X4014, and WS-X4013+ supervisor
engines, perform the following task:
To disable multicast suppression on the Catalyst 4900M, Catalyst 4948E, Supervisor Engine 6-E, or
Supervisor Engine 6L-E, perform this task:
Step 7
Switch# show storm-control broadcast
Verifies your entries.
Step 8
Switch# copy running-config startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# interface interface-id
Enters interface configuration mode and enter the port to
configure.
Step 3
Switch(config-if)# [no] storm-control
broadcast include multicast
Enables multicast suppression.
Step 4
Switch(config-if)# end
Returns to configuration mode.
Step 5
Switch(config)# end
Returns to privileged EXEC mode.
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# [no] storm-control
broadcast include multicast
Enables and disables multicast suppression.
Step 3
Switch(config-if)# no storm-control
broadcast level
Disables port storm control (broadcast and multicast).
Step 4
Switch(config-if)# end
Returns to configuration mode.
Step 5
Switch(config)# end
Returns to privileged EXEC mode.