Filter
Top Products
59-7
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 59 Configuring Call Home
Configuring Call Home
You can select one or more alert groups to be received by a destination profile.
Note A Call Home alert is only sent to destination profiles that have subscribed to the alert group containing
that Call Home alert. In addition, the alert group must be enabled.
To subscribe a destination profile to an alert group, perform this task:
Command Purpose
Step 1
Switch# configure terminal
Enters configuration mode.
Step 2
Switch(config)# call-home
Enters Call Home configuration submode.
Step 3
Switch(cfg-call-home)# alert-group
{all|configuration|diagnostic|
environment|inventory|syslog}
Enables the specified alert group. Use the
keyword all to enable all alert groups. By
default, all alert groups are enabled.
Step 4
Switch(cfg-call-home)# profile name
Enters the Call Home destination profile
configuration submode for the specified
destination profile.
Step 5
Switch(cfg-call-home-profile)#
subscribe-to-alert-group configuration
[periodic {daily hh:mm | monthly date hh:mm |
weekly day hh:mm}]
Subscribes this destination profile to the
Configuration alert group. The Configuration
alert group can be configured for periodic
notification, as described in the “Configuring
Periodic Notification” section on page 59-8.
Switch(cfg-call-home-profile)#
subscribe-to-alert-group all
Subscribes to all available alert groups.
Step 6
Switch(cfg-call-home-profile)#
subscribe-to-alert-group diagnostic
[severity catastrophic|disaster|
fatal|critical|major|minor|warning|
notification|normal|debugging]
Subscribes this destination profile to the
Diagnostic alert group. The Diagnostic alert
group can be configured to filter messages based
on severity, as described in the “Configuring
Message Severity Threshold” section on
page 59-8.
Step 7
Switch(cfg-call-home-profile)#
subscribe-to-alert-group environment
[severity catastrophic|disaster|
fatal|critical|major|minor|warning|
notification|normal|debugging]
Subscribes this destination profile to the
Environment alert group. The Environment alert
group can be configured to filter messages based
on severity, as described in the “Configuring
Message Severity Threshold” section on
page 59-8.
Step 8
Switch(cfg-call-home-profile)#
subscribe-to-alert-group inventory
[periodic {daily hh:mm | monthly date hh:mm |
weekly day hh:mm}]
Subscribes this destination profile to the
Inventory alert group. The Inventory alert group
can be configured for periodic notification, as
described in the “Configuring Periodic
Notification” section on page 59-8.