Filter
Top Products
CHAPTER
6-1
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
6
Configuring Interfaces
This chapter describes how to configure interfaces for the Catalyst 4500 series switches. It also provides
guidelines, procedures, and configuration examples.
This chapter includes the following major sections:
• About Interface Configuration, page 6-2
• Using the interface Command, page 6-2
• Configuring a Range of Interfaces, page 6-4
• Using the Ethernet Management Port, page 6-6
• Defining and Using Interface-Range Macros, page 6-10
• Deploying SFP+ in X2 Ports, page 6-11
• Deploying 10-Gigabit Ethernet and Gigabit Ethernet SFP Ports on Supervisor Engine V-10GE,
page 6-12
• Deploying 10-Gigabit Ethernet or Gigabit Ethernet Ports on Supervisor Engine 6-E, Supervisor
Engine 6L-E and WS-X4606-X2-E, page 6-13
• Invoking Shared-Backplane Uplink Mode on Supervisor Engine 6-E, page 6-16
• Digital Optical Monitoring Transceiver Support, page 6-16
• Configuring Optional Interface Features, page 6-17
• Understanding Online Insertion and Removal, page 6-30
• Monitoring and Maintaining the Interface, page 6-30
Note For complete syntax and usage information for the switch commands used in this chapter, look at the
Cisco Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If the command is not found in the Catalyst 4500 Command Reference, it is located in the larger Cisco
IOS library. Refer to the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html