Filter
Top Products
Configuring Switch Information 249
are connected to each other, a crossover cable is used ensure that the correct pairs are connected.
Auto MDIX does not operate on FE ports if auto negotiation is disabled. The possible field
values are:
Auto
— Use to automatically detect the cable type.
MDIX
— Use for hubs and switches.
MDI
— Use for end stations.
Current MDI/MDIX
— Indicates the current device MDIX settings. The possible field values are:
MDI
— The current MDI setting is MDI.
MDIX
— The current MDI setting is MDIX.
LAG
— Specifies if the port is part of a LAG.
NOTE: If port configuration is modified while the port is a LAG member, the configuration change is
only effective after the port is removed from the LAG.
Defining Port Parameters
1
Open the
Port Configuration
page.
2
Select a port in the
Port
Field.
3
Define the available fields in the dialog.
4
Click
Apply Changes
.
The port parameters are saved to the device.
Displaying the Port Table
1
Open the
Port Configuration
page.
2
Click
Show All
.
The
Port Configuration Table
opens.
Figure 7-13. Port Configuration Table