Dell 3424P Computer Accessories User Manual


 
Configuring PowerConnect 3424/P and 3448/P 65
Wizard Step 6
The CLI prompt is displayed.
Advanced Configuration
This section provides information about dynamic allocation of IP addresses and security
management based on the Authentication, Authorization, and Accounting (AAA) mechanism, and
includes the following topics:
Configuring IP Addresses through DHCP
Configuring IP Addresses through BOOTP
Security Management and Password Configuration
When configuring/receiving IP addresses through DHCP and BOOTP, the configuration received
from these servers includes the IP address and may include subnet mask and default gateway.
Retrieving an IP Address From a DHCP Server
When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. When
the device is reset, the DHCP command is saved in the configuration file, but the IP address is not.
To retrieve an IP address from a DHCP server, perform the following steps:
1
Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, in
order to retrieve the IP address.
2
Enter the following commands to use the selected port for receiving the IP address. In the
following example, the commands are based on the port type used for configuration.
Assigning Dynamic IP Addresses:
console# configure
console(config)# interface ethernet 1/e1
console(config-if)# ip address dhcp hostname powerconnect
console(config-if)# exit
console(config)#
Assigning Dynamic IP Addresses (on a VLAN):
console# configure
console(config)# interface ethernet vlan 1
console(config-if)# ip address dhcp hostname device
console(config-if)# exit
console(config)#