Filter
Top Products
Configuring PowerConnect 3424/P and 3448/P 73
To recover a lost password when entering the local terminal only:
1
From the Startup menu, type
[3]
and press
<Enter>
. The password is deleted.
Enter your choice or press 'ESC' to exit:
Current password will be ignored!
NOTE: To ensure device security, reconfigure passwords for applicable management methods.
Enter Diagnostic Mode - option[4]
For Technical Support only.
Set Terminal Baud-Rate - option[5]
To set the terminal baud-rate, type
[5]
and press
<Enter>
.
Enter your choice or press 'ESC' to exit:
Set new device baud-rate: 38,400
Software Download Through TFTP Server
This section contains instructions for downloading device software (system and boot images)
through a TFTP server. The TFTP server must be configured before downloading the software.
System Image Download
The device boots and runs when decompressing the system image from the flash memory area
where a copy of the system image is stored. When a new image is downloaded, it is saved in the
other area allocated for the other system image copy.
On the next boot, the device will decompress and run from the currently active system image
unless chosen otherwise.
To download a system image through the TFTP server:
1
Ensure that an IP address is configured on one of the device ports and pings can be sent to a
TFTP server.
2
Make sure that the file to be downloaded is saved on the TFTP server (the
arc
file).
3
Enter the
show version
command to verify which software version is currently running on the
device. The following is an example of the information that appears:
console# show version
SW version 1.0.0.30 (date 27-Jan-2005 time 13:42:41)
Boot version 1.0.0.05 (date 27-Jan-2005 time 15:12:20)
HW version