Filter
Top Products
378 Configuring Quality of Service
www.dell.com | support.dell.com
The
Interface Settings
page contains the following fields:
Interface
— The specific port or LAG to configure.
Disable "Trust" Mode on Interface
— Disables Trust mode on the specified interface. This setting
overrides the Trust mode configured on the device globally.
Set Default CoS For Incoming Traffic To
— Sets the default CoS tag value for untagged packets.
The CoS tag values are 0-7. The default value is 0.
Assigning QoS settings for an interface:
1
Open the
Interface Settings
page.
2
Select an interface in the
Interface
field.
3
Define the fields.
4
Click
Apply Changes
.
The CoS settings are assigned to the interface.
Displaying QoS/CoS settings:
1
Open the
Interface Settings
page.
2
Click
Show All
.
The Interface Table is displayed.
Assigning QoS Interfaces Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the
Interface Settings
page.
The following is an example of the CLI commands:
Table 9-110. QoS Interface CLI Commands
CLI Command Description
qos trust Enables the trust mode.
no qos trust Disables Trust state on each port.
console(config)# interface ethernet 1/e15
console(config-if)# qos trust