Filter
Top Products
62 Configuring PowerConnect 3424/P and 3448/P
www.dell.com | support.dell.com
The system will prompt you with a default answer; by pressing
enter, you accept the default.
You must respond to the next question to run the setup wizard
within 60 seconds, otherwise the system will continue with
normal operation using the default system configuration.
Would you like to enter the Setup Wizard (you must answer this
question within 60 seconds? (Y/N)[Y]Y
You can exit the Setup Wizard at any time by entering [ctrl+Z].
If you enter [N], the Setup Wizard exits. If there is no response within 60 seconds, the Setup
Wizard automatically exits and the CLI console prompt appears.
If you enter [Y], the Setup Wizard provides interactive guidance through the initial device
configuration.
NOTE: If there is no response within 60 seconds, and there is a BootP server on the network, an address
is retrieved from the BootP server.
NOTE: You can exit the Setup Wizard at any time by entering [ctrl+z].
Wizard Step 1
The following is displayed:
The system is not setup for SNMP management by default.
To manage the switch using SNMP (required for Dell Network
Manager) you can
•
Setup the initial SNMP version 2 account now.
•
Return later and setup additional SNMP v1/v3 accounts.
For more information on setting up SNMP accounts, please see
the user documentation.
Would you like to setup the SNMP management interface now?
(Y/N)[Y]Y
Enter [N] to skip to Step 2.
Enter [Y] to continue the Setup Wizard. The following is displayed:
To setup the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access
the switch. The wizard automatically assigns the highest access
level [Privilege Level 15] to this account.
You can use Dell Network Manager or CLI to change this setting,
and to add additional management systems. For more information
on adding management systems, see the user documentation.
To add a management station: