Filter
Top Products
322 Configuring Switch Information
www.dell.com | support.dell.com
The following is an example of the CLI commands:
Defining LAG Membership
The device supports eight LAGs per system, and eight ports per LAG, whether the device is a
stand-alone device or in a stack.
When a port is added to a LAG, the port acquires the LAG’s properties. If the port cannot be
configured with the LAG’s properties, it is not added to the LAG. An error message is generated.
However, if the first port joining the LAG cannot be configured with the LAG settings, the port is
added to the LAG, using the port default settings. An error message is generated. However, as this
is the only port in the LAG, the entire LAG operates with the port’s settings, instead of the LAG’s
defined settings.
Use the
LAG Membership
page to assign ports to LAGs. To open the
LAG Membership
page,
click
Switch
→
Link Aggregation
→
LAG Membership
in the tree view.
Console (config)# lacp system-priority 120
Console (config)# interface ethernet 1/e11
Console (config-if)# lacp port-priority 247
Console (config-if)# lacp timeout long
Console (config-if)# end
Console# show lacp ethernet 1/e11 statistics
Port 1/e11 LACP Statistics:
LACP PDUs sent:2
LACP PDUs received:2