Filter
Top Products
Installing System Components 121
Figure 3-29. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1
Connect the intrusion-switch cable to its system board connector. See
Figure 3-29.
2
Insert the switch into the opening in the chassis wall and gently, but firmly,
press in the switch until it is fully seated. See Figure 3-29.
3
Close the system. See "Closing the System" on page 66.
4
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 intrusion switch 2 intrusion switch cable
1
2