Filter
Top Products
Installing System Components 97
9
Press down on the memory module with your thumbs while pulling up on
the ejectors with your index fingers to lock the memory module into the
socket.
When the memory module is properly seated in the socket, the ejectors on
the memory module socket align with the ejectors on the other sockets
that have memory modules installed.
10
Repeat step 6 through step 9 of this procedure to install the remaining
memory modules. See
Table 3- 1 o r Ta bl e 3-2
.
11
Replace the cooling shroud assembly:
– If you are installing memory modules on the system board, see
"Replacing the Cooling Shroud Assembly" on page 70.
– If you are installing memory modules on the PEM, see Figure 3-9.
12
Replace the PEM. See "Replacing the PEM or PEM Shell" on page 76.
13
Close the system. See "Closing the System" on page 66.
14
Start up the system, press <F2> to enter the System Setup program, and
check the
System Memory
setting on the main System Setup screen.
The system should have already changed the value to reflect the newly
installed memory.
15
If the value is incorrect, one or more of the memory modules may not be
installed properly. Repeat step 2 through step 14 of this procedure,
checking to ensure that the memory modules are firmly seated in their
sockets.
16
Run the system memory test in the system diagnostics. See "Running the
System Diagnostics" on page 167.
Removing Memory Modules
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.